[. . . ] Repairs Disconnect the appliance from the mains as soon as a fault is detected. Any repairs, such as replacing a damaged power cable, may only be carried out by our Customer Services team in order to avoid potential danger. [. . . ] Please refer here to the section brewing stage or there is c ­ irst Time Use, Steps 2 – 14. The appliance does not Clean the T DISC reading window with a soft, recognise the T DISC bar damp cloth. Smooth out the foil of the T DISC with your finger so that the bar code can be read. Clean the brewing unit with a soft, damp cloth, paying particular attention to the lid area. Switch on the appliance before inserting the T DISC Press the piercing unit into its holder using both thumbs and check the position of the T DISC support. The T DISC has not been Replace the damaged T DISC with a new one. Place the T DISC with the printed side facing downwards so that the tab is resting in the intended slot. Clean the brewing unit with a soft, damp cloth, paying particular attention to the lid area. En 10 Troubleshooting Problem Cause Solution H The brewing unit cannot The brewing unit is still be opened. Wait until the Status LED S has stopped blink­ ing before attempting to open the brewing unit. Fill water tank R lights up even though there is enough water in the water tank. Fill water tank R and Descale Q are flashing simulta­ eously and it is n not possible to prepare drinks. Turn the machine off using the On / Off switch, wait approximately 5 minutes and turn the machine back on. If R and Q are still flashing, please contact the ­ ASSIMO careline. [. . . ] The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. [. . . ]